As you can see from the photo’s there is not much paint left, So I assumed they where painted in the same color as the base frame of the front seats (White with a greenish tint).
After everything is painted in epoxy primer and the greenish white, it was reassembled again. The 8 small metal tubes are used as a final stop, to prevent the runner is moving too far outside the base part. The place where the ball are rolling are left unpainted to guarantied a smooth operation.
]]>

After inspecting I found out that the surface of all parts where made very rough and before I could start painting it had to be sanded very well. I also had to straighten out some sheet metal parts because they very distorted. The right door also show some kind of dent and will need to be repaired.
The same hold for the left door because the lower part of the door has been replace completely
After the sand blasting I also found two parts which show holes through the metal which are in need to be welded before they can be painted.

All parts are, as mentioned before, sanded and painted in 2K Epoxy primer, before they are painted in the correct color;
The last items which are still in need of some fresh layer epoxy primer are;