I started with dis-assembling everything. Most parts still looks fine and can be finished with some retouching especially the upper part, which is made of cast aluminium, is finished with special wrinkle paint. The rest of the painted parts are just in gloss black paint. To prevent leakages after installing I pressure test the heater core with 0.5 bar (normally the cool system of the car will not become higher then 4 LBS). Although the heater core has signs of leakage the core is still water tight. After glass beat blasting and cleaning it can be finished with several layers of gloss black paint. The upper part is painted only partly the preserve the numbers painted on it from the factory.
Now that all parts are thoroughly cleaned, painted and retouched everything can be re-assembled again. Also the 12V motor has been tested, after applying some crease inside, it spins without making any noise. (the carbon brushes are OK, and there is no play on the bearings)
]]>When this part has been mounted the water circuit has been finished and can be filled with coolant. The paper hoses will also be mounted but the chrome windshield defrosters, which are connected at the other side, are mounted when the dashboard is fitted.




During installation of the ignition coil bracket I found out that the right upper corner should have a chamfered edge. This part has been bought new because the original one was missing. With the current shape the throttle axis hits the bracket at the location mentioned before.
The clamp used to fix the distributor on the engine block was also missing. After several attempts, to buy an used or new one failed, I decided to make one myself. The nut and bolt, shown on the left side of the clamp, are reused from a different wrong model clamp.
The ignition sequence is 1, 5, 3, 6, 2, 4. Plug number one is at the rear of the engine, number 6 at the front.
Cylinder 1 and 6, 2 and 5, 3 and 4 are moving synchronous. They also switch between the front three cylinders and rear three cylinders between each ignition. (Most probably to get a good distribution of the forces on the crankshaft) So this is the reason the ignition sequence is a bit strange.
After inspecting the wiper motor, located inside the left front wing, came to the following conclusion:
As seen on the last photo two windscreen wipers can be connected and will be set in motion by the gears, located behind polished lid. The cable in the parts overview will be pushed and pulled back and forth to get the wiper arms in movement. This engine has 5 electrical connections as shown in the schematic below
]]>